Please contact us using the information below.
M-F 9am-5pm ET
WE ARE LOCATED AT
445 Park Avenue, Suite 16A
New York, NY 10022
SlipX Solutions Non-Slip New popularity Adhesive Shower Suction Mat No Cups SlipX Solutions Non-Slip New popularity Adhesive Shower Suction Mat No Cups $9 SlipX Solutions Non-Slip Adhesive Shower Mat, No Suction Cups! ( Home Kitchen Bath Bathroom Accessories $9 SlipX Solutions Non-Slip Adhesive Shower Mat, No Suction Cups! ( Home Kitchen Bath Bathroom Accessories (,Cups!,$9,Non-Slip,Home Kitchen , Bath , Bathroom Accessories,Adhesive,Shower,No,Suction,Mat,,Solutions,SlipX,www.128lebanon.com,/otology812300.html (,Cups!,$9,Non-Slip,Home Kitchen , Bath , Bathroom Accessories,Adhesive,Shower,No,Suction,Mat,,Solutions,SlipX,www.128lebanon.com,/otology812300.html
Finally, a shower mat without suction cups! SlipX Solutions Large Adhesive Traction Mat applies to non-textured surfaces with a powerful adhesive. This adhesive mat works perfectly for shower stalls, bathtubs, stairs and other slippery spots where you want permanent non-slip protection.
Adhesive Traction Mat Installation Instructions
What Youâll Need: Pencil, Non-Metal Smoothing Tool
IMPORTANT: Avoid installing over grout lines or voids, all of which may affect adhesion. This product is not for use on textured or refinished surfaces. The mat cannot be repositioned after installation.
How to Install: Clean tub using a tub/tile cleanser. Dry completely. Wipe surface with rubbing alcohol to remove any remaining residue. Dry completely. With paper backing still in place, place mat in desired location. If a different shape or size is desired, trim mat to fit application surface by measuring new mat size with ruler first then cutting with scissors. Holding mat in place, lightly trace around the mat edge using a pencil.
Attach Mat to Surface: Carefully wash and dry your hands. Peel 1-2 inches of the paper backing away from one edge of the mat. Slightly crease backing to keep adhesive surface exposed. Avoid touching adhesive as much as possible. Position the exposed mat edge (paper side down) within your tracing marks and firmly press exposed mat edge onto clean application surface. Working one small section at a time, peel paper backing away from mat, then press newly exposed adhesive area onto surface. Use your smoothing tool as you go, in an outward motion from the center of the mat outward to avoid air bubbles and create an even, smooth bond between your mat and the application surface. If you encounter a trapped air bubble that you cannot eliminate with your smoothing tool, prick the bubble with a needle and re-smooth that area. Ensure that all mat edges lay completely flat and are securely adhered to the application surface.